Caspian Journal of Dental Research

8-15

Authors: Mitra Tabari, Ziba Nourali*, Iman Jahanian, Soraya Khafri

Introduction: Evaluation is a tool that can be used to achieve the goals of higher education. The aim of this study was to evaluate the achievement level of educational objectives in Babol dental school using the CIPP (content, input, process, and product) model based on the point of view of students. Materials&Methods: This cross-sectional study was performed using a researcher-made questionnaire based on CIPP model for educational groups of oral and maxillofacial surgery (OMFS), endodontics and periodontics among dental students admitted to Babol University of Medical Sciences in 2008 and 2009. Total scores were calculated for each field and categorized as undesirable, relatively desirable and desirable with scores less than 50, 51-70 and 71-100, respectively. Statistical analysis was performed using ANOVA, T-test and Tukey HSD tests and P <0.05 was considered significant. Results: The mean scores of four areas were not significantly different between groups for two entries using ANOVA test. By comparing two groups, the mean scores of input area were significantly different in periodontics (p=0.007) and OMFS (p=0.002) departments. Conclusion: Achieving to educational goals within the context area was desirable in all departments. But there are some problems in other studied areas which must be pay attention.

24-29

Authors: Ehsan Moudi*, Sina Haghanifar, Kave Kazemian, Ramin Foroughi, Mehrdad Nabahati, Ali Bijani

Introduction: Diagnosis of lesions and bone defects is very important and there is a lack of substantial studies on the most appropriate method for bone defect measurement. Hence, the aim of this study is to evaluate the accuracy of multi-slice computed tomography (MSCT) and cone-beam computed tomography (CBCT) in the diagnosis of mandibular bone defects present in sheep. Material & Methods: This in vitro study was performed on 15 sheep's mandibular bones. Some defects were created in cortical and spongy bone using high-speed hand piece at the buccal and lingual cortical bone of the lower jaw. Totally, 75 mandibular bone defects with a depth of 1-3 mm were created. The mandibular bone samples were scanned using MSCT and CBCT scanners, and these scans were evaluated by two oral and maxillofacial radiologists. The positive and negative predictive values, sensitivity and specificity were calculated for both methods. Results: The sensitivity of MSCT and CBCT were 78% and 96.5%, and Specificity of MSCT and CBCT were 90% and 92% respectively. The positive and negative predictive values were 97.5% and 89.5 % for CBCT, and 90% and 92% for MSC respectively. The negative and positive likelihood ratios (LR-) and (LR+) were 0.035 and 13.04 for CBCT as well as 0.245 and 7.82 for MSC respectively. Conclusion: The study results demonstrated a higher accuracy of CBCT, compared to MSCT, in the diagnosis of bone defects.

38-43

Authors: Mahtab Hamzeh , Farida Abesi, Soraya Khafri, Ana Rakhshandejoo*

Introduction: Considering the good geometry and possibility of simultaneous observation of the roots of the maxillary and mandibular molars in vertical bitewing radiography, the present study was conducted to evaluate the accuracy of vertical bitewing radiography in determination of root length of maxillary primary molars. Material & Methods: One hundred first primary molars and forty second primary molars which were planned to be extracted for reasons other than this study, were used in this cross-sectional study. All radiographs were taken by a radiologist with vertical bitewing technique using XCP pediatric bitewing film holder. The root length was measured from the highest visible point of the occlusal surface to the most apical point of the root using caliper with accuracy of 0.1 mm. After removing the teeth, the length of each root was measured from the highest point at the occlusal surface to the tip of the root. Data were entered into SPSS 20 and analyzed using Pearson correlation and one sample t-test. Significance level was considered as 0.05. Results: According to the results of one sample t-test, although the root length was estimated slightly higher than the actual size in all cases, the difference was significant only for distobuccal root of the first primary molar (P˂0.05). The results of Pearson correlation test showed that in 95% of cases, the true root length values were consistent with those measured by radiography. Conclusion: Based on the results of this study, except for distobuccal root of first primary molar, the vertical bitewing could precisely determine the root length of primary molars.

49-53

Authors: Masoumeh Mehdipour, Mojdeh Hakemi Vala, Maryam-Sadat Sadrzadeh-Afshar, Narges Gholizadeh*

Introduction: Cinnamon zeylanicum is used for various medical purposes. The aim of this study was to compare the antifungal efficacy of cinnamon and amphotericin B against Candida species in vitro. Material & Methods: Candida albicans (C. albicans) and Candida krusei (C. Krusei) were obtained from the Iranian Industrial and Scientific Research Center. The minimum inhibitory concentration (MIC) of cinnamon extract was determined and compared with that of amphotericin B. Results: The results of this study showed that Amphotericin B, ethanolic and aqueous extract of cinnamon inhibited the growth of C. albicans and C. Krusei with different MICs. Conclusion: Ethanolic extract of cinnamon has inhibitory effects on Candida species comparable to that of amphotericin B. So, it can be used as a herbal alternative.